Installed radiusd sarg snort in clustpc3 and clustpc4. configured (continued activity from yesterday) and activated snort with public rulesets.

BR-06 of BioTA is not working. Found all outgoing data since 01 Oct 2013 is not available for many users. Went with prabhakar to check in the turnstile room. It looks there is some problem in the network link from the reader to the non-snmp switch in Turntile room. Instructed prabhakar what to be done. He corrected by 12:30PM. Next data timing is around 2:30 PM, I checked the pending data sync status, looked Ok.

Talked to Mr Ajit of Synchronous, Ranchi on BioTA reader requested him to provide a proforma invoice for delivery of the BioTA reader so that I can start processing. I shall procure one fist then another in few days after integration into our system.

In DHCPD changed few groups as clustpc4 looks overloaded and clustpc3 under loaded. But still the same situation looks only one / few clients putting up the load.

 Tried Development versions of squid3 and squid3-squidguard in clustpc4 for failed to start and work correctly even after installation of required libraries. At last uninstalled and install 2.7 version of squid and corresponding squidguard. Configured squid and sarg in both clustpc3 and clustpc4. Both tested and working fine. Squid is presently in transparent mode to be changed for authentication. Sarg is with 7 day archive and 1 hour analysis mode. Checked and working fine. SquidGuard and squidauth to be configured later.